Agricultural irrigation clamps for hose fastening

Agricultural irrigation clamps provide a practical method of fastening hoses within irrigation installations. Available irrigation hose clips include wormdrive clips and W1 Super clips, with different materials, type designations and dimensions. Matching these details to the hose connection helps identify a suitable clip for the required assembly.

Hose clips for irrigation are available in galvanised steel and stainless steel 304. The configurations comprise steel type W1 wormdrive clips, steel type W1 Super clips and stainless steel 304 type W4 wormdrive clips. These distinctions allow agricultural irrigation clamps to be compared by material, clip design and size.

Wormdrive hose clips

Wormdrive hose clips are represented by galvanised steel W1 and stainless steel 304 W4 configurations. Examples of the stated size ranges include 10 mm x 16 mm, 25 mm x 40 mm and 40 mm x 60 mm. Depending on the configuration, additional measurements of 9 mm or 12 mm are specified. Check every stated measurement rather than selecting an irrigation hose clip by material alone.

W1 Super hose clips

Galvanised steel W1 Super hose clips provide another agricultural hose fastening configuration. A 30 mm x 33 mm version with a stated 20 mm measurement is available, alongside multiple variants. W1 Super clips should be distinguished from standard W1 wormdrive clips during selection because the type designation and dimensions differ.

Choosing irrigation hose clips and clamps

Begin by confirming the dimensions required at the hose fastening point. Agricultural hose clamps are supplied across multiple sizes, so both values in the specified size range should be checked against the intended hose connection. An irrigation clamp that has the correct material but does not match the required dimensions is not the appropriate configuration for the assembly.

Compare material and type designation

Material is a clear point of comparison. Galvanised steel is used for type W1 wormdrive clips and W1 Super clips, while stainless steel 304 is used for type W4 wormdrive clips. Select between these configurations according to the material requirement of the irrigation installation. Do not assume that W1, W1 Super and W4 are interchangeable, as each designation identifies a different clip configuration.

Check every stated dimension

Irrigation hose clips carry a size range in millimetres and may also have an additional millimetre measurement. Available examples combine 10 mm x 16 mm with 12 mm, 25 mm x 40 mm with 12 mm, 40 mm x 60 mm with 9 mm, and 30 mm x 33 mm with 20 mm. Compare the complete specification when replacing an existing clip or preparing a new hose assembly.

Keep clip specifications consistent

For repeat agricultural hose fastening work, record the selected material, type designation and complete dimensions. This helps distinguish visually similar irrigation clamps and supports consistent selection for comparable hose connections. Where an existing clip is being replaced, use its confirmed specification as the reference rather than relying only on its appearance.

Hose clips for agricultural irrigation

Galvanised W1, galvanised W1 Super and stainless steel 304 W4 clips cover several hose fastening requirements. Compare the available irrigation hose clips by design, material and millimetre dimensions before choosing a configuration. This provides a direct basis for matching the clamp to the intended agricultural irrigation hose assembly.